Borla Muffler FS: $50 in DFW
11-03-2007, 01:57 PM
#1
Mustang Moderator
Thread Starter
iTrader: (1)
Join Date: Jan 2002
Location: Houston/Denton TX
Posts: 1,637
Likes: 0
Received 0 Likes
on
0 Posts
Borla Muffler FS: $50 in DFW It is a polished Borla muffler off of an F-body cat-back. It is the muffler only, no pipes or tips. This means it is 3" in on one side, and 3" out on the other side.
There is a small dent on one end of the muffler, but it does not affect the performance or sound. It has about 30k miles on it.
Just looking to get what I bought it for, $50 firm! I'm located in the Lake Dallas area, which is about halfway between Lewisville and Denton on I-35. I can ship if you'd like, but the buyer will pay for all shipping costs.
Thanks guys!
Arron
There is a small dent on one end of the muffler, but it does not affect the performance or sound. It has about 30k miles on it.
Just looking to get what I bought it for, $50 firm! I'm located in the Lake Dallas area, which is about halfway between Lewisville and Denton on I-35. I can ship if you'd like, but the buyer will pay for all shipping costs.
Thanks guys!
Arron
Trending Topics
11-05-2007, 05:41 PM
#11
Mustang Moderator
Thread Starter
iTrader: (1)
Join Date: Jan 2002
Location: Houston/Denton TX
Posts: 1,637
Likes: 0
Received 0 Likes
on
0 Posts
You COULD just have it welded on, but this muffler is set up to be used as a single in and single out muffler. So, if you used it on an f-body, it would be a single exit muffler.
To illustrate, here is what the entire system looked like:
That is the ENTIRE system. I am selling only the MUFFLER out of that system. If you want to duplicate this system for cheap, I'd just weld in the muffler and install a cut-out before the muffler. This will allow you to be loud and wide open when you want, and be able to cap the cut-out and tone things down when you don't want to be as obnoxious.
Any other questions, feel free to ask!
Arron
