Need Tips Installed But For $60!?!?!
06-09-2008, 11:31 AM
#1
TECH Veteran
Thread Starter
iTrader: (4)
Join Date: Aug 2006
Location: San Marcos/Plano, Texas
Posts: 4,821
Likes: 0
Received 0 Likes
on
0 Posts
Need Tips Installed But For $60!?!?! Ok ive been quoted by two shops, one asking 60 the other 75. Im sorry but this is way too freakin high for what they actually do. It's an easy job and theyre obviously ripping people off with these prices. Does anyone know a shop around plano/north dallas that does ti[s for cheap and does a good job. Ive seen people pay 25 and have yet to find the luck to find this kind of shop
but after the install
06-09-2008, 12:00 PM
#6
TECH Fanatic
Join Date: Nov 2001
Location: Houston
Posts: 1,876
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
06-09-2008, 12:10 PM
#9
TECH Senior Member
iTrader: (1)
Join Date: Apr 2005
Location: Vancouver,[KITSILANO].B.C. Canada *WestCoast*
Posts: 8,807
Likes: 0
Received 0 Likes
on
0 Posts
WELL..to take 2 off and weld 2 on properly...will take around 60 minutes.[and no,mine don't stick out past the bumper...camera angle...should change pic]haha..
06-09-2008, 12:12 PM
#10
Launching!
iTrader: (13)
Join Date: Jul 2004
Location: fort worth texas
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
yup pay up they have to cut the old ones, align and weld the new ones,
ive had a 25 dollar tip install years ago and it looked like ****...
you get what you paid for
ive had a 25 dollar tip install years ago and it looked like ****...
you get what you paid for
06-09-2008, 12:15 PM
#11
TECH Veteran
Thread Starter
iTrader: (4)
Join Date: Aug 2006
Location: San Marcos/Plano, Texas
Posts: 4,821
Likes: 0
Received 0 Likes
on
0 Posts
!they look like they are stretched over the bumperyup yup yup
06-09-2008, 11:53 PM
#19
Teching In
iTrader: (8)
Join Date: Nov 2007
Location: seabrook
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Three years ago when i was in college at OU i had a full exhaust installed on my nissan/datsun 82zxt from the down pipe out to the rear bumper. I provided the mandrel bends and the shop cut and welded it all together for 100$. If a shop wanted 60$ just to cut and weld two tips on i would go buy a used flux core mig welder for @100$ and do it myself, at least you have a welder to play around with and it pays for itself the next time you need exhaust work done.
