Bent Frame..... Repair it?
I figure this just gives me an excuse to cut it all out and put a tube frame up front. I do aircraft structure repair for a living, so I'm pretty comfortable with fabrication. I just haven't done anything this involved on a car before and was hoping for afew suggestions on specific things to watch for before I get started. Here's the kit I was thinking of using, and afew quick pictures of the problem area.
http://www.cachassisworks.com/p-535-...x-2-frame.aspx

Last edited by turbinesurgeon; Sep 13, 2011 at 10:19 PM.
Perhaps I could get a basic 4 point roll cage, and tie it to the front with an extra bar that bends down for the door then back up at the dash.
A year ago I was doing alot of research into putting AWD into a car that didn't have it with an LS V-8 to boot. This car would be a good car to start with since it needs alot of fab work on the floor and up front anyway.
This is going to be a long-term project
I have a lot of family in that business, and wrinkles like that is a complete HACK job. That panel should have been cut/replaced after being pulled straight. I'm almost willing to bet $$ that the car isn't straight.
Trending Topics
The Best V8 Stories One Small Block at Time




