My car went under the knife today...
#64
Hey Ryan, good job!!!!.. you saved lots of $$$$$..doing the R&R!!!!..
are u ready to Rumble????...ha....i did a 7.4 last nite on Just Motor didn't get
a chance to apply the sauce......are you going to be ready for Invasion???
sounds like u r......
are u ready to Rumble????...ha....i did a 7.4 last nite on Just Motor didn't get
a chance to apply the sauce......are you going to be ready for Invasion???
sounds like u r......
#65
that torque still amazes me...... but that was the intention when i advance the intake 4 degrees, but i wasnt suspecting that much torque, but with the right cam and compression torque can be made
#67
Well the results are in!
I have an oxy sensor cutting in and out so im going back today to install a couple new denso oxy sensors and have Ryne clean up the idle a little bit.
Tha final numbers were 468 RWHP and 434 RWTQ!
I was expecting about 460rwhp and 410rwtq so that torque being up there surprised both Ryne and I.
The cars running great and has lots of power, I can tell a good difference from the old setup.
Big thanks to Ryne for staying until after 1am to get it done!
I have an oxy sensor cutting in and out so im going back today to install a couple new denso oxy sensors and have Ryne clean up the idle a little bit.
Tha final numbers were 468 RWHP and 434 RWTQ!
I was expecting about 460rwhp and 410rwtq so that torque being up there surprised both Ryne and I.
The cars running great and has lots of power, I can tell a good difference from the old setup.
Big thanks to Ryne for staying until after 1am to get it done!
been thinking for a while of getting a 96/96 combo with a larger cam... just not sure which one yet... but I wanna get as close to 500rwhp as possible NA
Killer numbers bro!
UPDATE THAT SIG!
Last edited by Soul TKR; 05-23-2009 at 05:21 AM.
#68
Thread Starter
TECH Fanatic
iTrader: (71)
Joined: Dec 2007
Posts: 1,885
Likes: 1
From: Southern California
Well im hoping to pick up a pair of prostars today for my ET Streets, if not Will is going to loan me some MT DRs. Thats a good time man, if thats on motor im not sure ill have a chance with you on spray, ill have to get my juice on and well go to irwindale one of these weeks.
#69
Thread Starter
TECH Fanatic
iTrader: (71)
Joined: Dec 2007
Posts: 1,885
Likes: 1
From: Southern California
With your combo and a larger cam with a FAST you should be pretty close to 500 wheel...send that car to CMS!.....updating sig