325/30/19 on the back, whole lot of BFHing with 79mm offset and 20mm spacers, 4th Gen rear end.

With very minimal cutting I can remove the spacers.

 

nice ride, im not a fan of the wing but nice ride

 

they will fit man! do work on those inner fenders! i actually seen 2-3 more camaros with 19x12's 59mm offset running 325s!

remember---they dont just 'fit'...its up to you to MAKE them fit!!!!

 

I have quite a few of mine with C6 Z06 take offs on it....PM me if you want pics cause photobucket is ****** up on me......

 

Aren't the ZR1 rims 20X12 though? Not 19X12?

 

Yes they are 20x12 in the rear but...this thread is dealing with OEM Z06 wheels, not ZR1 wheels.

 

Does anyone know what kind of spacers I should use. The rear wheels are rubbing on the inside right around the bump stop area. The front wheels are fine.I got the wheels on but I only got crappy camera phone pics and it was night time. I cant wait to post the finished product. And thank all of you for the useful information!!!

 

you have to trim some of that metal out of the bump stop area...

you dont need to run spacers to run those wheels.

do a search on the bfh mod, those wheels dont just bolt on and go...you have to MAKE THEM FIT...

 

So I got the wheels on but I dont wanna post pics until I'm dont. I got the fenders rolled but theres a little section that just doesn't wanna roll. I'm frustrated because it keeps rubbing on the tire. I mite just try to carefully hammer it in. Did you have the same problem zacht?

 

im still in the process of making mine all fit correctly...ive put about 800 miles on the setup. i have to do a little more trimming on the bumpstop, little more bfh mod. i havent rolled my fenders yet, im at stock ride height...so im 4x4 right now...

not sure why that part isnt rolling in for you. i havent rolled mine yet. your in the same boat im in...they fit..but still rub a little...just keep plugging away at it. i know they will fit good. ive seen half a dozen cars with these wheels on the rear making them fit...

 

Well good news and bad news zacht. Good news is I found where the rub was (inner fender well), grabbed the bfh and went at it. Appearantly the rubbing is gone. Bad news is I accidentally put a dent on my quarter panel and its fuuuugly. But anyways, the car looks great with these wheels. I have to find the cord to upload the pics off of my camera. Thanks for your help. If u want I can Email em' from my phone haha!

 

i just have this image in my head of you going crazy with the hammer and hitting the quarter lol

 

BOB99SS that's not it. I accidentally hit it with some pliers. I fail lol

 

Its actually very tiny but the car is black so you know how that goes

 

Its actually very tiny but the car is black so you know how that goes

 

i want to see some pics! if you can email them to me ill try and post them up!

zachtower@yahoo.com

 

That wing is stock. They came from the factory like that. It looked good then and it still looks good now.

 

got some of mateo's pics! ill post em up! they're bad ***...also. what you got for suspension???
[IMG][/IMG]

[IMG][/IMG]

 

dang good looking SS!

 

Thx zacht good lookin out man. All I really have is eibach sportlines to lower it. With the exception of lakewood control arms everything is pretty much stock down there!