315s on a C6 Rim?
Thread Starter
TECH Resident
iTrader: (12)
Joined: Jul 2004
Posts: 987
Likes: 1
From: Georgetown, IL 61846-1105
315s on a C6 Rim? Hey guys, I have the OE Corvette Backspacing on a set of C6 rims, I got the Hubcentric Spacers that LethalSS had...I believe it's like 1.25"...I plan on rolling the fenders. Do you think I could fit 315's back there with the setup? I would like to get as much meat back there as I can, since the 396 will get GMR Speed's TT setup....The car is lowered, and has all aftermarket susp. parts....Will be going Ford 9" soon (before the project is complete)
Sorry for the late post.... yes they will work without them but you have to do a lot of massaging to the inner fenders. Not a good shot but this is without the spacers installed and still at stock ride height.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I have a 285 out back.... wanted to go wider but not much is offered in a 19". Like mentioned above, a 315 nitto would probably be your best bet if you would rather not use the spacers.
