bigradical

iTrader: (3)

What size spacers are people running on the front when using 15x3.5 Weld Draglites? A buddy of mine said he was running a 5/8" spacer but that seems awfully thick to be running on factory sized studs. Any help would be appreciated.

Also, is everyone running shafted lug nuts or just regular lug nuts?

chpmnsws6

iTrader: (70)

5/16's inch spacers

LS69TA

iTrader: (30)

5/16" spacer, and I believe it's 1.380 legnth, .687 diameter (shank style) lugnuts. Even with the smaller 5/16" spacer, I didn't feel safe using them because I had roughly 3-4 full turns of the lugnuts holding the wheel on the stock studs. After grinding the calipers, I had about 12+ turns.

chpmnsws6

iTrader: (70)

If you need a set of spacers, i have a set from when i had prostars.... shoot me a PM if you need em

bigradical

iTrader: (3)

I might just end up grinding the calipers. About how much grinding is necessary to make them fit with no spacers?

If I do decide to run spacers, then I'll shoot you a line. Thnx for the offer.

chpmnsws6

iTrader: (70)

sounds good. You'll start getting scared and then finally put the spacers on. 5/16ths of an inch is ALOT to be grinding off a caliper

RaNsOm

iTrader: (2)

Grinding the back is no big deal, the calipers are considerably smaller than the fronts. I couldnt imagine grinding the fronts just to run skinnies. I'll stick with my 5/16's thank you

OOOJOHN

im using a 1/4 inch spacer up front and a 5/16 spacer in the back.