Fox body Header problem...Help
#1
9 Second Club
Thread Starter
iTrader: (10)
Join Date: Jul 2009
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Fox body Header problem...Help
Hey guys. I'm using the AJE K member but used the stock mustang trans cross member. The problem I'm having is on the driver side the collector is obstructed from hooking up an X pipe by where the cross member connects to the body. Has anyone else had this problem. Using Dynatech headers.
The exhaust shop told me the only two options they could think of is to build a different trans cross member and cut the mount off the body or cut the collectors on the headers back some.
What do you guys think? Here's a pic, not the best in the world though.
The exhaust shop told me the only two options they could think of is to build a different trans cross member and cut the mount off the body or cut the collectors on the headers back some.
What do you guys think? Here's a pic, not the best in the world though.
Trending Topics
#10
9 Second Club
Thread Starter
iTrader: (10)
Join Date: Jul 2009
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Ok guys, now I got the plugs and wires on and the #3 plug wire is hitting the primary tube. I'm using the MSD 32829 Multi Angle plug wires.
What do you think my options are? I've seen some heat socks at Advanced Auto Parts but not sure that will be ok. Or should I try a different kind of wire on that cylinder. Thanks
What do you think my options are? I've seen some heat socks at Advanced Auto Parts but not sure that will be ok. Or should I try a different kind of wire on that cylinder. Thanks
#13
9 Second Club
Thread Starter
iTrader: (10)
Join Date: Jul 2009
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Ok, got the car running. Now need to figure this exhaust out. Wanna have the rest of my stuff here before I go to muffler shop to see what they can do about this collector.
My plan is 3" X pipe into bullets with turn downs. What do you guys think? Was gonna get the universal kit from summit unless someone has a better idea lol
My plan is 3" X pipe into bullets with turn downs. What do you guys think? Was gonna get the universal kit from summit unless someone has a better idea lol
#17
9 Second Club
Thread Starter
iTrader: (10)
Join Date: Jul 2009
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Here's a better pic of what I'm running into on the driver header. Since I've heard this is a "common" problem. Does this look about normal? I used a T5 mount cause a TH350 mount made the engine tilt back 6 degrees.
What do you think?
What do you think?