JerikSS

iTrader: (2)

I have a 5lb spring in my wastegate, and I am going to run an electronic boost controller, when everything is installed, when I turn on the boost controller will it be at 5psi or will there be some guess work involved???

2002/Black/SS

iTrader: (3)

depends on the type of boost controller, also u really have a 232/228 cam? i might be wrong but dosent a 228/232 sound better?

JerikSS

iTrader: (2)

its a profec b spec 2, if it helps dont want to overboost.

Ping King

iTrader: (20)

reverse splits are good for turbos.

JerikSS

iTrader: (2)

Like ping king, i was under the impression that reverse split cams were better for turbos........i am fairly new so i might be totally wrong.

MECHAM

iTrader: (4)

when u hook up the BC...and u turn the boost off/down to the lowest setting (for my Eboost this would be setting 00)...it will go off the WG spring 5psi in yr case.

2002/Black/SS

iTrader: (3)

the profect should have a instructions manual right? also im under the impressuon that the profec when it is first started up puts boost to 0 automaticly, so ur boost will be wtvr ur spring is set for also the profec should have a mas boost limiter that u can set for safety

JerikSS

iTrader: (2)

so if the profec b puts it to 0 and my wastegate has a 5lb spring, i will have to just add 3lbs on the profect to come to 8lbs of total boost, am i right?

MECHAM

iTrader: (4)

no..u would set the BC to 8psi...

cause anything less than 5psi you dial in on the BC will be negated by the WG spring 5psi.

JerikSS

iTrader: (2)

so my limit of how low i could go would be 5lbs due to the spring...i get it thaks guys