Mavns Quick Performance 9" Install.
#1
Mavns Quick Performance 9" Install.
Heres some Pics from my Quick Performance 9" Install.
Things I had to modify:
1: Torque Arm Mount was too wide and my TQ arm would NOT Line up so I had to grind it down.
2: I had to literally Cut 1 coil off of my 2" Lowerng springs because the spring Pirch was sitting too tall I Looked like I had a lift kit lol
3: Torque arm would NOT Fit in the tunnel so I had to take a Hammer to it lol
Now that its In its Fantastic. I need to modify the tunnel some more .
[non-sponsor pricing removed]
Pics:
Things I had to modify:
1: Torque Arm Mount was too wide and my TQ arm would NOT Line up so I had to grind it down.
2: I had to literally Cut 1 coil off of my 2" Lowerng springs because the spring Pirch was sitting too tall I Looked like I had a lift kit lol
3: Torque arm would NOT Fit in the tunnel so I had to take a Hammer to it lol
Now that its In its Fantastic. I need to modify the tunnel some more .
[non-sponsor pricing removed]
Pics:
#15
TECH Fanatic
I've put two Midwest chassis fab 9's in and had no trouble at all. No modifying no beating just install it and go. I wasn't aware the stamped steel housings had these issues
#16
This is an issue with all stamped housing of course some worse than others and why we mount our torque arm the way we do eliminating the stock style torque arm configuration.
#18
Those reasons above are what sets us apart from companies that are just parts slingers. Not to mention we keep in contact with our customers, customers are and will always give valued feedback.
#19
LS1Tech Sponsor
iTrader: (16)
Moser has been building fabricated 9 inch rears since 2007, they come with an excellent chromoly torque arm that is telescopic, and has plenty of clearance.
Contrary to what one vendor on here has mentioned, Moser's fabricated rear also comes with a drain and a large fill as standard equipment.
Moser is one of the few companies that design their own rear who also make their own center section and axles.
Moser's fabricated 9 inch rears do not come with brake line clips built on to the housing, but if you can live without brake line clips a moser fabricated 9 inch that isn't powder coated typically ships out the same week it is ordered.
http://shop.brutespeed.com/Moser-M9-...y-Complete.htm
If you order a Moser rear through Brute Speed, sway bar brackets come standard. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
#20
TECH Fanatic
This is happens because the only way you can fit a torque arm onto a stamped housing is to move the pinion closer to the passenger side and the mounting points closer to the drivers side.
This is an issue with all stamped housing of course some worse than others and why we mount our torque arm the way we do eliminating the stock style torque arm configuration.
This is an issue with all stamped housing of course some worse than others and why we mount our torque arm the way we do eliminating the stock style torque arm configuration.