supersick99z

iTrader: (66)

I'm sure this subject has been beaten to death, but searching I couldn't find what I was looking for at all! Few ?'s:

1. Where did everyone mount their switch? I have a 99' LS1 M6. Pics would be great.
2. I know you can buy different switches from local auto parts stores, but doesn't the QTP one have a like plug on one of the wire ends?

I'm really not trying to cut my console or other pieces up badly just to install a switch so pics would be great help!

Thanks!

01ssreda4

iTrader: (96)

Here's mine:

supersick99z

iTrader: (66)

Is that a QTP switch?

01ssreda4

iTrader: (96)

It's a switch from Parts Express. I chose it because I liked how low profile it was and the fact that it blended in.

Sladester2

iTrader: (1)

There is a write up somewhere on here where you put the switch on the side of the driver seat. It looks quite simple to put it there.

Guitar

iTrader: (9)

I would put it where my convertible switch is (I suppose where your change holder is?) under your radio.

02ws.sik

There is a rubber gromet you run the line through on the pass side. Drill a hole run the wire under the carpet to the center console. Take off center console and run it too the ash tray so no one c.an see it

supersick99z

iTrader: (66)

That's the plan right now since I don't use the ashtray anyway and I rather cut up a cheap piece to replace rather than an entire console

xX-Z28-Xx

iTrader: (4)

Emblem Pros makes some, so do some nitrous vendors. Just look around. I've seen some pretty cool ones.

Steve Gunn

SLP4CamaroSS

iTrader: (16)

i have mine where the astry light would be at

6898camaross

That's pretty slick!

01ssreda4

iTrader: (96)

Actually, I did not select this location of my own free will. The previous owner drilled a hole there before I bought the car and the hole has sat unused for years so I killed two birds with one stone. I just had to make the hole a tad bigger to run the switch I wanted.

02ws.sik

Dont you hit it with your leg. Ive had change in the ashtray and its done it before?

RedRocketZ28

iTrader: (19)

That's where mine was. Worked out great.

supersick99z

iTrader: (66)

Do you guys have a QTP rectangle shaped switch?