00sscam

Ok can you help me figure this out.

Went and bought polyurtheane motor mounts

took the clam shell out and was suprised i drilled out the the 3 rivets on one side.the other side of the shell had solid mushroom head rivets.

now there is no way to clamp the shell together anymore i will have to get bolts and put bolts through the solid rivet side .

what is going on i though this was pop the rivets and swap it out .

I am worried the bolts i will have to put in is going to hold the clam together

Any ideas would be help full .

thanks chris

Argon Z

Picture would be very helpful

00sscam

Ya i know i forgot to take it with me i do not know what to do i do not want to take the other mount out and leave the moter suspended like that. I will try to take a shot of the other mount in the car tomorrow.

00PewterSS

iTrader: (3)

What you are describing is normal.

The Prothane mounts come with the bolts. I don't know what kind you bought, but I would advise buying some bolts and nylon lock washers. You need 2 bolts on each side of the clam shell... in other words 4 bolts per mount. Make sure the head is on the engine side.

Brian

TAQuickness

iTrader: (28)

I pressed mine together with a vice and welded it

MM98

iTrader: (13)

I just did my driverside mount tonite & was wandering the exact same thing... I bought the energy mounts & they come with 2 stupid zip ties!!!! I ran outa time at work & will have to redo it again next week... 00 PewterSS, thanks for the info!

Mike

Full-Force

iTrader: (11)

People need to stop buying those stupid energy suspension mounts. The Prothanes come with everything you need.

00sscam

Ok ran in to another problem i got it all together and went t6o go test fit the clam shell in the pedistil and ther is .5" of play side to side is this normal it can't be.

The original mount fit tight in the pedistal now i have .5" of play side to side that an't right

Part Number is # 3-1116 energy suspension black insert

has any one else had this problem

OldeSkool