Head Gasket > .060 Compressed
#1
TECH Fanatic
Thread Starter
iTrader: (22)
Join Date: Dec 2004
Location: Fishers, IN
Posts: 1,232
Likes: 0
Received 0 Likes
on
0 Posts
Head Gasket > .060 Compressed
I'm in need of a head gasket (4 inch bore) that has a compressed thickness of greater than .060. My current setup is putting me out of the hole too much with the stock MLS gaskets. Anybody know of a good one?
Thanks!
Thanks!
#7
TECH Fanatic
Thread Starter
iTrader: (22)
Join Date: Dec 2004
Location: Fishers, IN
Posts: 1,232
Likes: 0
Received 0 Likes
on
0 Posts
Haha, sorry. That was a typo. They are .020 out....one too many zero's. I was going to run the gm mls gasket, but that would put me around .034 quench. Ive always been told that .040 is about as tight as you wanna go.