side molding help
#1
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2004
Location: pensacola, fl.
Posts: 1,555
Likes: 0
Received 0 Likes
on
0 Posts
side molding help
ok i got a silver ss i just bought. i want to take the side moldings off but on the pass. side door and quarter they repainted it and just taped around it..i dont want to paint the car again and a painter said i could get some 1500 and knock down the hard edge and then lightly buff it out. only thing is im scared its going to look like **** cuz the car is clean other wise..what should i do leave the molding on and deal wth it or risk taking it off and try knocking down the egde? help me out
justin
justin
#5
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2004
Location: pensacola, fl.
Posts: 1,555
Likes: 0
Received 0 Likes
on
0 Posts
i pulled them off and to my suprise they based and cleared to the bottom of them..so its got a HARD line and it wont sang off unless i burn threw the clear..so i either have to order new moldings or get it painted..
Trending Topics
#8
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2004
Location: pensacola, fl.
Posts: 1,555
Likes: 0
Received 0 Likes
on
0 Posts
no they based and cleared the bottom of the rocker, door, and fender. and left the molding on so it has a hard tape line where the bottom of the molding was..the old moldings are fine just the tape is all half ripped off and all that..i think im just goin to get it fixed right (repainted) that way i dont have have to worry about it later...
#11
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2004
Location: pensacola, fl.
Posts: 1,555
Likes: 0
Received 0 Likes
on
0 Posts
yeah thats the way im looking at it.. i mean i could put the molding back on. but ill still know that its there and it will bugg the hell out of me not knowing its done right. so im just going to get it fixed when i get the extra coin...thanx for the help guys!