Installing a 100 Wet Shot
#1
Teching In
Thread Starter
Join Date: Jan 2006
Location: Magnolia NJ
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Installing a 100 Wet Shot
I am looking to run a 100 Wet Shot of NO2 on my 1999 Trans Am.
Its an all stock bottom end ls1 with the stock heads..These are the only mods that I have done to the car:
Engine:
K&N Filter
SLP Air Lid
MAC Long Tube Headers - Offroad Y Pipe to SLP Loudmouth 1
TSP 233/239 .595 .603 112LSA
TSP Pushrods
Crane Lifters
LS6 Oil Pump
Transmission:
Fuddle 3600 Stall Convertor
B&M Trans Cooler
Stock 10 bolt with 3.42
The best I have ran with this setup is 11.9. Just wondering what you think the car would run on a 100 wet shot and any good reliable companies to have the install done at. I am located in South Jersey
Its an all stock bottom end ls1 with the stock heads..These are the only mods that I have done to the car:
Engine:
K&N Filter
SLP Air Lid
MAC Long Tube Headers - Offroad Y Pipe to SLP Loudmouth 1
TSP 233/239 .595 .603 112LSA
TSP Pushrods
Crane Lifters
LS6 Oil Pump
Transmission:
Fuddle 3600 Stall Convertor
B&M Trans Cooler
Stock 10 bolt with 3.42
The best I have ran with this setup is 11.9. Just wondering what you think the car would run on a 100 wet shot and any good reliable companies to have the install done at. I am located in South Jersey
#5
10 Second Club
iTrader: (3)
I had dozens more in the upper 1.4's and ~40 more runs in the 1.5's... You just need to prevent wheel hop and you should be good to go. Im not saying it wont break, but having an A4 surely helps.
A wideband is a good idea if you have some extra cash...