JMAC

iTrader: (38)

Where or who do I need to talk to for a Firehawk front bumper cover 98-02. I have a new Trans Am cover but my hood seats on top of the bumper around the ram air.
Any info would be greatly appreciated

Kyles03

The Firehawk bumper is a normal T/A bumper cover, its just cut to fit the Firehawk hood iirc.

1965GP

iTrader: (2)

That's right- cut the factory bumper

JMAC

iTrader: (38)

So afraid to cut my new bumper but I'll try it, Thanks guys.

Manic Mechanic

iTrader: (3)

You'll have to plan for capping or smoothing out the cut off edge. SLP glued down a triangular cap that has the firehawk emblem on it. They are obsolete but can still be found from time to time in sale ads. I would imagine something could be fabricated or the material could be sculpted with appropriate filler to make a clean edge.

Vernon

1965GP

iTrader: (2)

I think you can still get the emblem on eBay- I bought 2 or 3 extra cause they were only like $12

DopeFedZ

iTrader: (34)

https://ls1tech.com/forums/texas-mem...per-cover.html

Just take it to a professional bodyshop if you are afraid to mess with it.

1965GP

iTrader: (2)

Or drink a few beers first...

JMAC

iTrader: (38)

I will not be doing it for sure, I was hoping someone has 1 for sale. But Thanks again.

DopeFedZ

iTrader: (34)

The same way your hood is sitting on top of the bumper trace an outline on the bumper then cut it. I used a dremel took like 15 mins

1965GP

iTrader: (2)

There is one of the emblems on eBay with a buy it now of $36.

JMAC

iTrader: (38)

OK, Thanks for info

I'll Look for it now