FormulaFire

iTrader: (20)

Would it be best to use a smooth bellow like that sold by SLP or will the nozzle work fine on the stock accordian style hose? I have a NX wet kit.

Nitro Dave's Nitrous Outlet

iTrader: (25)

We have put them in the stock accordian boot many times.The two piece not does a great job at tighting it down.However the smooth bellow makes it easer.
Dave

XTrooper

I'd invest in a smooth bellows if I were you.

FormulaFire

iTrader: (20)

I had a fernco from home depot, but it just wouldn't fit. It wasn't flexible enough to make the angle from the MAF to the Throttle Body. So I had to trash it and use the stocker for my N20 setup. I guess the SLP would work better???

MrDude_1

iTrader: (4)

get the furnco and put it in the microwave.
then with gloves on, take it out and bend it so it has the needed angle.

Nitro Dave's Nitrous Outlet

iTrader: (25)

Hmmm,Never thought of doing that.Thats awesome if it works good.
Dave

The Sad

iTrader: (8)

Becareful not to get it too hot. We cooked my friends.

MrDude_1

iTrader: (4)

a few of my friends did that to get it to fit on the throttlebody... but they still had the usual "straight" when it needs to be "angled" problem i just heated it up again and bent it until it was cool... worked pretty good.

hourang

iTrader: (6)

the fernco works best when you put it in almost boiling water for a lil bit. i have a hot water tap at my house and i just put it in a bowl for like not even a minute and it was 10x softer. microwave works too but the hot water is safer, can leave it in as long as you want im sure.

gollum

iTrader: (1)

I wish I had a hot water tap in my house.

hourang

iTrader: (6)

yeah we just installed one, wasnt hard, and is instant roman noodles, lol.