tilly

iTrader: (5)

Hello,

Is there any of our lovely sponors sell a spacer for the ram air hoods where it seals the intake to the hood. I already have the F.R.A.M already done to the air box, K&N and an after market lid. Just looking for some little bolt on stuff to add to make things a little more efficient.

Tilly

Tainted

iTrader: (9)

you have an SS hood, there is no "ram air". it jsut flat out sucks. if you want a bolt on for "ram air" get the SSRA

fortmyerspolice

iTrader: (7)

Patrick G made a 1" spacer out of something, but it was for a ws6 hood. I was thinking about doing it but I really can't find anything good to use.

Tainted

iTrader: (9)

buy 2 of the BGRA spacers from afterthoughtsauto.com

2 will fit but you may have to trim part of one down. it will make a very good tight seal

fortmyerspolice

iTrader: (7)

kind of expensive, I'm going to try and find something at homedepot, maybe a piece of rubber or something and cut it

Tainted

iTrader: (9)

weather stripping for porch doors

tilly

iTrader: (5)

YEa I know its nto ram air. But its a source of cold air. I read some where not sure but the air temperature drops when it sucks through the hood scoop.

Tainted

iTrader: (9)

maybe on a WS6 but not on an SS. the SS scoop is right on top of the motor and gets heat soaked. not enough air comes through that hood until very high speeds to make a difference anyway

fortmyerspolice

iTrader: (7)

Yeah Patrick G said he saw a decrease in intake temp on his ws6