Owners of Whisper 1 7/8" Headers inside please
#1
Staging Lane
Thread Starter
Join Date: Jun 2002
Location: Plano, TX
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Owners of Whisper 1 7/8" Headers inside please
I currently have these whisper headers and two cutouts on the Y-pipe right now. I am considering going with the Kooks 1 7/8" stepped headers with X-pipe and dumps before the rear. The motor is a 408 stroker.
My question is do you guys think I would see any gains going to this setup instead of my current.
thanks,
Rusty
My question is do you guys think I would see any gains going to this setup instead of my current.
thanks,
Rusty
#7
TECH Senior Member
iTrader: (6)
Re: Owners of Whisper 1 7/8
Hehe.. hope you weren't looking for many "actual" owners of Whisper headers.. there aren't many.
I have a set on my stock internals car.
The only places I see you could pick up would the area around the steering shaft and the extra length of the collector.
If it was me, I'd focus in other areas first... there might be a little horsepower to gain, but not enough to justify the cost.
I have a set on my stock internals car.
The only places I see you could pick up would the area around the steering shaft and the extra length of the collector.
If it was me, I'd focus in other areas first... there might be a little horsepower to gain, but not enough to justify the cost.
Trending Topics
#8
Staging Lane
Thread Starter
Join Date: Jun 2002
Location: Plano, TX
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Re: Owners of Whisper 1 7/8
Thanks WILWAXU, that's what I was kinda thinking also.. Probably just spend the money on one of the new intakes that they are coming out with.
#9
TECH Senior Member
Re: Owners of Whisper 1 7/8
I am also an owner of them. I used them on my 9.82 setup.
I don't think you'll gain much, if any, by going to a 1 7/8-2" stepped header...if that's what you were suggesting. Your Whisper headers flow plenty for that engine, IMO.
I don't think you'll gain much, if any, by going to a 1 7/8-2" stepped header...if that's what you were suggesting. Your Whisper headers flow plenty for that engine, IMO.