96 WS6 cut hole in front bumper/ hp estimate
#1
TECH Enthusiast
Thread Starter
iTrader: (12)
Join Date: Aug 2006
Location: Texas
Posts: 533
Likes: 0
Received 0 Likes
on
0 Posts
96 WS6 cut hole in front bumper/ hp estimate
block work getting done and ready in about 4 weeks (Busy time of the year for machine shop) . And well I removed the front bumper and thinking of cutting 2 big holes in the front for the inter-cooler (32x12x4) Just wondering if it would look right.. i will rework it so it won't look unfinished, I will probably add at least 3 inches of lip going toward ic.... It will be something like this but with an LT1 front bumper (Like to stick to the roots, and let everyone know it's an lt1 not an ls1)...
On a side note what do you think my LT1 will make to the wheels
Parts list:
Eagle 4340 crank 3.480" stroke
Eagle h-beam 5.7" rods
Diamond -22cc dished pistons .030" over
RealQuicks Log manifold hot parts
Ebay intercooler and piping
TC76 with the new F-1 GTK turbine / .96 ar
Parts pending
Saving to get TF 62cc heads and custom AI cam for my turbo setup...
Tuner cat
65# injectors (yes I know I will be limited by my injectors)
Parts for sale:
Brett bauer blower cam ( new) 200.00 shipped
Comp cam springs (new) ???
Damn I threw in a little bit of everything in here... Your opinions will be gladly taken good or bad...
On a side note what do you think my LT1 will make to the wheels
Parts list:
Eagle 4340 crank 3.480" stroke
Eagle h-beam 5.7" rods
Diamond -22cc dished pistons .030" over
RealQuicks Log manifold hot parts
Ebay intercooler and piping
TC76 with the new F-1 GTK turbine / .96 ar
Parts pending
Saving to get TF 62cc heads and custom AI cam for my turbo setup...
Tuner cat
65# injectors (yes I know I will be limited by my injectors)
Parts for sale:
Brett bauer blower cam ( new) 200.00 shipped
Comp cam springs (new) ???
Damn I threw in a little bit of everything in here... Your opinions will be gladly taken good or bad...
Trending Topics
#11
#12
TECH Senior Member
iTrader: (36)
block work getting done and ready in about 4 weeks (Busy time of the year for machine shop) . And well I removed the front bumper and thinking of cutting 2 big holes in the front for the inter-cooler (32x12x4) Just wondering if it would look right.. i will rework it so it won't look unfinished, I will probably add at least 3 inches of lip going toward ic.... It will be something like this but with an LT1 front bumper (Like to stick to the roots, and let everyone know it's an lt1 not an ls1)...
EDIT: Found a better example:
Do this, but with a LT1 bumper, I think it should come out similarly. Good luck.