DIY head porting question
#1
On The Tree
Thread Starter
iTrader: (7)
Join Date: Feb 2008
Location: wisconsin
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
DIY head porting question
I have a question concerning the casting for the rocker arm bolts in the runners of the lt1 heads.
Can I smooth those out and if I were to poke through and reach the threaded hole for the rocker stud would this cause an issue.
For example, I have this going on.........
And was wondering if I could do this...................
I am thinking a thread sealant on the rocker studs would stop any vacuum leaks, but I am just looking for some second opinions
Can I smooth those out and if I were to poke through and reach the threaded hole for the rocker stud would this cause an issue.
For example, I have this going on.........
And was wondering if I could do this...................
I am thinking a thread sealant on the rocker studs would stop any vacuum leaks, but I am just looking for some second opinions
Last edited by mtperformance; 06-03-2011 at 01:37 PM.
Trending Topics
#8
TECH Fanatic
Join Date: Jan 2004
Location: Kingfisher Oklahoma
Posts: 1,157
Likes: 0
Received 0 Likes
on
0 Posts