TNTramair

iTrader: (15)

anyone using the Exo-skel??? how do you like it? engagement? how much HP etc etc?

thanx

rick

pewter01z

iTrader: (44)

Its a little stiffer than stock. Releases close to the top (better for fast shifitng) should hold a shitload of power. Does have a little chatter but once you beat on it a little and get it hot it goes away. I'm currently not putting near enough power thru it but hopefully that will be changing in the near future and I'll be ready!!!!

TNTramair

iTrader: (15)

BUMP...anyone else?

speedracer5532

iTrader: (8)

So far I only have about 100 miles on mine. Releases about in the middle, no chatter, shim behind slave and stock master cylinder. So far I love this clutch.

TNTramair

iTrader: (15)

Textralia suggest using a shim with it?? or just something you decided to do?

speedracer5532

iTrader: (8)

I think they suggest not using one but I had one in there before and I thought about it when I installed the Exo-skel and decided to leave it in.

pewter01z

iTrader: (44)

They specifically told me NOT to use any shims or aftermarket master cylinders.

deejaydaze

iTrader: (11)

I wonder if that goes for the OZ700 ?

To shim or not to shim?

TNTramair

iTrader: (15)

I know for sure your not supposed to use a shim with the OZ700.

deejaydaze

iTrader: (11)

You know I haven't read the installation papers in the box (assuming there are some instructions)

But how do you know?

TNTramair

iTrader: (15)

b/c i had one and was one of the first guys to purchase it when it came out....i did my research and talked to the guys over a Textralia to confirm. i had a Spec 3 before which was shimmed and it was something i needed to make sure.

deejaydaze

iTrader: (11)

THANKS MAN!!

What do you think about putting in a new slave? I have the 01-02 slave and it's about 2 years old.

TNTramair

iTrader: (15)

kit comes with a new slave....i would replace it with the one provided.

Ferocity02

iTrader: (60)

Yeah, Textralia doesn't believe in shims on any of their products.