short throw shifter
#2
TECH Resident
Trending Topics
#9
Staging Lane
Join Date: Jun 2012
Location: Hutto / Round Rock, TX
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
If you have a newer MGW that's not stepped you can just cut the end off that goes in the shifter. No retreading needed. If you have the old style rod you might just get a new one from them?
#11
On The Tree
iTrader: (3)
Join Date: Mar 2009
Location: Ohio
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
I think I have the new style, there is a little notch about an inch and a half from the bottom that has a groove around it, and the instructions say to cut it there if you want it shorter. Hope that helps!
#12
On The Tree
Join Date: May 2012
Location: Port St. Lucie, FL
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
I thought the MGW was a little shorter than the stock shift stick?
I just ordered mine last night. I don't mind how the Hurst I have sits now, is there a height difference from the two?
I just ordered mine last night. I don't mind how the Hurst I have sits now, is there a height difference from the two?
#14
On The Tree
Join Date: May 2012
Location: Port St. Lucie, FL
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
I don't mind how it sits stock to be honest. But looking at the WS6Store..man that looks right!
#15
I notice when ordering mgw shifter there are two options for thread. One is stock and the other is a different thread/pitch. What are you guys ordering. Btw sorry to butt in on your thread but didn't want to start a new one for a simple explanation.