Preogramming LC1 Analog Output
11-14-2009, 09:57 AM
#1
12 Second Club
Thread Starter
iTrader: (7)
Join Date: Oct 2005
Location: NYC
Posts: 1,666
Likes: 0
Received 0 Likes
on
0 Posts
Preogramming LC1 Analog Output How long does it take to program an LC1 analog output? I was trying to program it and it was taking forever. I tried to get out of it but it then crashed my pc.
11-14-2009, 01:44 PM
#2
FormerVendor
iTrader: (9)
Join Date: May 2003
Location: Jacksonville, Fl
Posts: 1,573
Likes: 0
Received 0 Likes
on
0 Posts
It takes as long as cycling the power. Once you have programmed the new values the LC-1 will sit there in programing mode until you cycle the power for the new settings to take effect.
11-14-2009, 04:10 PM
#5
12 Second Club
Thread Starter
iTrader: (7)
Join Date: Oct 2005
Location: NYC
Posts: 1,666
Likes: 0
Received 0 Likes
on
0 Posts
how much time do i give it before i turn it off. do i just hit program and then turn the switch off? also just want to confirm whether i program it with the car running or just with the key in the on position?
11-14-2009, 04:42 PM
#6
You just need to have the LC-1 powered on, do it with the engine off.
I hit the program button and wait 5 seconds then
turn it off for 10 seconds before I turn it back on.
It does not give confirmation dialog box after wards but it will still be programmed.
I hit the program button and wait 5 seconds then
turn it off for 10 seconds before I turn it back on.
It does not give confirmation dialog box after wards but it will still be programmed.
Trending Topics
11-14-2009, 06:54 PM
#8
12 Second Club
Thread Starter
iTrader: (7)
Join Date: Oct 2005
Location: NYC
Posts: 1,666
Likes: 0
Received 0 Likes
on
0 Posts
mission successful. programmed the output and logging through my pcm now. since its an lt1 i used the ac pressure sensor to send the signal from the lc1 to the pcm.
