Maybe a dumb ?
#1
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Apr 2008
Location: Covington ,GA
Posts: 1,111
Likes: 0
Received 0 Likes
on
0 Posts
Maybe a dumb ?
I am doing my install, and can't remember which side is pos or neg on this speaker wire. Just want to make sure. Both sides are clear and one side has a red line going down the center of it. Thanks for the help. You can see some of the things I am install in this forum:
https://ls1tech.com/forums/stereo-el...l-power-3.html
https://ls1tech.com/forums/stereo-el...l-power-3.html
Last edited by 98z8uup; 08-29-2010 at 12:04 PM.
#2
Staging Lane
iTrader: (1)
Join Date: Jun 2010
Location: KY
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure what it pos or neg could be, sounds like the red stripe would be pos. Why not take your voltmeter and take the ground from somewhere else and try the pos on the red stripe wire. If no voltage, try the other. It may not come out to be 12V but you would know. Take measurements with the unit off as well to confirm the readings.
Trending Topics
#10
Ungrounded Moderator
iTrader: (4)
It makes absolutely no difference which wire you use for positive or negative - wire is wire. As was said earlier, just pick one to use as positive and make sure you consistently use it the same throughout your wiring. For example, if you decide to use the red stripe for positive, connect the red stripe to the positive output of your amp and to the positive terminal on your speaker. Do the same for every connection and you won't have any problems.