6LE splitter on my LT1 bird
Trending Topics
#11
12 Second Club
iTrader: (26)
Join Date: Apr 2005
Location: Brockport NY
Posts: 1,456
Likes: 0
Received 0 Likes
on
0 Posts
It would look better if
1.) The car was lowered
2.) It was painted to match the car
3.) It was a black car and the splitter was painted gloss black.
I don't think it looks bad it has potential.
1.) The car was lowered
2.) It was painted to match the car
3.) It was a black car and the splitter was painted gloss black.
I don't think it looks bad it has potential.
#17
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: San Jose
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
here is a picture of the lines of the bumper and the splitter. I will go out in a bit and take pictures of the underside to show you what had to be done in order to make it fit.
#18
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: San Jose
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
her you can see how i had to enlarge the holes. I made them 2.5 inches longer
with the way it is now i prolly only needed about 1 to 1.5 inches bigger. Now these are the only hole on either side to match up.
The back slot near the front tire.
Then the front slots.
Overall to show how far forward it is.
with the way it is now i prolly only needed about 1 to 1.5 inches bigger. Now these are the only hole on either side to match up.
The back slot near the front tire.
Then the front slots.
Overall to show how far forward it is.
#20
Banned
iTrader: (56)
her you can see how i had to enlarge the holes. I made them 2.5 inches longer
with the way it is now i prolly only needed about 1 to 1.5 inches bigger. Now these are the only hole on either side to match up.
The back slot near the front tire.
Then the front slots.
Overall to show how far forward it is.
with the way it is now i prolly only needed about 1 to 1.5 inches bigger. Now these are the only hole on either side to match up.
The back slot near the front tire.
Then the front slots.
Overall to show how far forward it is.
I could easily make the design go further back and just move the holes back 2.5"s if someone wanted. Would increase cost though because it increases the size.
I think you're going to be a 1 of 1