!side molding + new wheels
Thread Starter
TECH Apprentice
iTrader: (2)
Joined: Aug 2006
Posts: 310
Likes: 0
From: OKC, OK & Hatteras Island, NC
!side molding + new wheels These are not the best photos I have taken, but I was not really in that kind of mood.
The location kind of sucked, but it was getting dark and I had no other place in mind. Car is leaning a bit, and make it look higher on the pass. side than what it really is.
The location kind of sucked, but it was getting dark and I had no other place in mind. Car is leaning a bit, and make it look higher on the pass. side than what it really is.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Thread Starter
TECH Apprentice
iTrader: (2)
Joined: Aug 2006
Posts: 310
Likes: 0
From: OKC, OK & Hatteras Island, NC
Thanks everyone
Yeah, the calipers are painted orange, and are a bit dirty. They could use a real good cleaning, and a re-paint. I was expecting everyone too say lower it. It is a work in progress, like most cars.
side markers are just the black ones, not nightshaded.
Yeah, the calipers are painted orange, and are a bit dirty. They could use a real good cleaning, and a re-paint. I was expecting everyone too say lower it. It is a work in progress, like most cars.
side markers are just the black ones, not nightshaded.
Thread Starter
TECH Apprentice
iTrader: (2)
Joined: Aug 2006
Posts: 310
Likes: 0
From: OKC, OK & Hatteras Island, NC
The car looks so much cleaner with out the side molding. It was very easy. Just grab a hair dryer, and heat up the pieces. Then grab a corner and peel back... I would go slow. Used my thumb to remove excess glue, and then just wipe it down with some detailer spray to remove the left over dirt. No color difference under the molding at all.
