Carbon Fiber Door Panels
#22
Thread Starter
FormerVendor
iTrader: (126)
Joined: Dec 2004
Posts: 1,399
Likes: 0
Received 0 Likes
on
0 Posts
From: Richmond, VA
Can you just make a real CF interior and not charge $1000? I see in your OP you have a CF dash but i dont see it on your site. Also a carbon fiber Trans Am rear bumper insert would be nice. Also an OEM Carbon Fiber LT1 WS6 hood. There isn't a single one on the market and people are always asking for it. I can loan you mine lol depending on where you are.
Yeah I can make that but it would be more expensive than something like door panels since it would have to be more layers of carbon.
#27
Thread Starter
FormerVendor
iTrader: (126)
Joined: Dec 2004
Posts: 1,399
Likes: 0
Received 0 Likes
on
0 Posts
From: Richmond, VA
What kind of price you talking?
Removing the sail panel is a pain in the ***, as seen HERE. However, I think the average guy here on LS1Tech could do it. I know that I haven't done it but if the right sail panel was available I'd give it a try.
Removing the sail panel is a pain in the ***, as seen HERE. However, I think the average guy here on LS1Tech could do it. I know that I haven't done it but if the right sail panel was available I'd give it a try.
That doesn't look horrible to remove as long as you dont care about keeping the old one in one piece.
#28
If you can make it cheaper than an OEM, I'm down for sure. Mines starting to bubble. Also, can we get some more pictures of that dash? That is SICK! I'd be interested in one if you can reproduce it as long as the price isn't absurd. I need something thats a direct factory replacement, so something like the VFN would be outa the question.
#31
Just your usual things, upper center console, radio bezel, door handle surrounds. Whats not so normal would be new AC vent cuffs, the part that slides into the dash that the vents click in to, and i think a carbon fiber gauge surround inlay would be nice. I mean just so that the inside of it is covered in CF rather than the whole awkward piece that would include the one air vent. Also map pocket covers!
#35
Thread Starter
FormerVendor
iTrader: (126)
Joined: Dec 2004
Posts: 1,399
Likes: 0
Received 0 Likes
on
0 Posts
From: Richmond, VA
If you can make it cheaper than an OEM, I'm down for sure. Mines starting to bubble. Also, can we get some more pictures of that dash? That is SICK! I'd be interested in one if you can reproduce it as long as the price isn't absurd. I need something thats a direct factory replacement, so something like the VFN would be outa the question.
Look through some of my other threads in the drag section and there are some more pics of the dash. I'm not interested in making them a production part though. WAY too much time in them unfortunately.
May be a possibility but that would be one of the harder parts to make since it would need thread inserts and mult. piece mold.
#39
TECH Enthusiast
iTrader: (11)
Joined: Jul 2005
Posts: 703
Likes: 0
Received 0 Likes
on
0 Posts
From: St Petersburg, FL
if you check out the sail panel threads and sticky, you may see that thousands of us would buy this... i think this would be your biggest seller. period. and beat the factory price? forget it: you would stand alone! ... do it