Interior mod.
The boot is fine. You'll just have to roll the top part down more when install. I would like to know how you wrap the leather inside the cup holder, and the cig lighter area. Everything is looking very good so far, BTW.
Thread Starter
TECH Fanatic
Joined: Jun 2004
Posts: 1,037
Likes: 18
From: Sweden
I have only wraped an inc or so down the holder. If you look at the cup holder you´ll notice its look like gloss black , i have painted the area inside. It is too much work to wrap in the cup holders.
I'd really like to see a pic of the cup holders in the back. I'm not really picturing how that could be done really nicely. I'm bet you made sure none of the pics showed that for that reason. I'm not expecting it to be perfect. I wanna get around to wrapping all my panels. I have all the materials already but hardly any time and its not priority with EVERYTHING else on the car is being worked on too. I'd do all the other panels first to learn, then I would do the console and dash. I might just cut the cupholders off and fiberglass it to look like it never existed.....then wrap it!
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I'd really like to see a pic of the cup holders in the back. I'm not really picturing how that could be done really nicely. I'm bet you made sure none of the pics showed that for that reason. I'm not expecting it to be perfect. I wanna get around to wrapping all my panels. I'd do all the other panels first to learn, then I would do the console and dash. I might just cut the cupholders off and fiberglass it to look like it never existed.....then wrap it!
Where are you guys getting your fabric? I'm kind of clueless, I was looking at Joann Fabrics for vynil just a minute ago
Thread Starter
TECH Fanatic
Joined: Jun 2004
Posts: 1,037
Likes: 18
From: Sweden
I'd really like to see a pic of the cup holders in the back. I'm not really picturing how that could be done really nicely. I'm bet you made sure none of the pics showed that for that reason. I'm not expecting it to be perfect. I wanna get around to wrapping all my panels. I have all the materials already but hardly any time and its not priority with EVERYTHING else on the car is being worked on too. I'd do all the other panels first to learn, then I would do the console and dash. I might just cut the cupholders off and fiberglass it to look like it never existed.....then wrap it!
Ok, some picsfrom the rear end of the console.This is really a PITA area to work on. I´m still working with the rear area to remove glue and touch it up with some black paint.
Thread Starter
TECH Fanatic
Joined: Jun 2004
Posts: 1,037
Likes: 18
From: Sweden
