HSW powder coated vic jr manifold
#1
FormerVendor
Thread Starter
iTrader: (6)
Join Date: Nov 2007
Location: Glenolden, PA
Posts: 1,593
Likes: 0
Received 0 Likes
on
0 Posts
HSW powder coated vic jr manifold
I thought i would share a few pictures of my intake we just wrapped up. Its a two stage setup with a wet plate pulling fuel from a methanol fuel cell and a dry direct port. obviously a lot went into the appearance. I sanded down the entire intake and powder coated it "smoked chrome" which is a two step process. I powder coated the rails black as well and used black fittings throughout with stainless soft and hard lines.
higher resolution pictures can be found here.
http://www.harrisspeedworks.com/gallery/
higher resolution pictures can be found here.
http://www.harrisspeedworks.com/gallery/