TransAxle resassembly guys plz chime in!!!
Thread Starter
TECH Addict
iTrader: (37)
Joined: Feb 2006
Posts: 2,714
Likes: 1
From: Tomball (H-Town), TX
TransAxle resassembly guys plz chime in!!! Nissan Maxima 93 Auto junkyard trans... need to put the big brake band back on I cant get it on for **** any ideas? I cant pinch it between the holders? also the band has a few little light light surface cracks I figure it will still work the clutches are good im selling the car for cheap
was wondering where these went (2 washers I assume around some bolt holes or something).. where stuck to the magnet when I opened it
heres the band
thanks, Ryan
was wondering where these went (2 washers I assume around some bolt holes or something).. where stuck to the magnet when I opened it
heres the band
thanks, Ryan
I wouldn't reuse the band at all. Especially the way stock clutch matl is. Not long and it is going to completely crumble away.
Last edited by 2002_Z28_Six_Speed; Dec 2, 2006 at 02:03 AM. Reason: Reword to reflect tone
The two gold washers look like the brass sealling washers for the coolant lines,but not sure,
to get he band in loosen the band ajusting pin slide it in a reajust ,
I allways liked doing the nissian trans
to get he band in loosen the band ajusting pin slide it in a reajust ,
I allways liked doing the nissian trans
__________________
Thread Starter
TECH Addict
iTrader: (37)
Joined: Feb 2006
Posts: 2,714
Likes: 1
From: Tomball (H-Town), TX
Originally Posted by performabuilt
The two gold washers look like the brass sealling washers for the coolant lines,but not sure,
to get he band in loosen the band ajusting pin slide it in a reajust ,
I allways liked doing the nissian trans
to get he band in loosen the band ajusting pin slide it in a reajust ,
I allways liked doing the nissian trans
ya i think thats what they are i dont get how they got in there
probably easiest to remove the servo from the side , then put band in.By the way bands only like 7 dollars , interestingly enough it work very similair to the 4l60e the band comes on in 2nd and 4th , it also has a 3-4 clutch all the way down in there and if the bands burned you can bet thy are fried , the do the same job with less than half the surface area the 4l60e has , Just some fyi
__________________
yes and you will probably need to get a lit with the steel plates to since the plates in the 3-4 clutch will most likley be warped, the 3-4 clutch so you will know is the little drum last thing that comes out
__________________
Trending Topics
Thread Starter
TECH Addict
iTrader: (37)
Joined: Feb 2006
Posts: 2,714
Likes: 1
From: Tomball (H-Town), TX
got new clutches and band in today.. problem is i put the damn things on the table in order and they fell off so i need the order they go in and I cant get the damn band on either 
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo holler at me tomorrow with your email and ill send you and exploded veiw
__________________
