No Reverse,Late shift in second
Thread Starter
9 Second Club
iTrader: (24)
Joined: Oct 2006
Posts: 2,796
Likes: 1
From: Kennesaw, Georgia
No Reverse,Late shift in second Trying to help a friend out with a few question's. On the way home from dinner he got on it and hit the revlimiter in second.Since then it will not shift into second until higher up in the rpm range and then it just rev;s. The other gear's are fine,then today went out to put the car in reverse and there is no reverse. This is in a 98 corvette with a 2800 stall.Any help will do!! 
FormerVendor
Joined: Oct 2006
Posts: 3,123
Likes: 3
From: D-F/W
He has toasted his tranny. Band burned up, servo leaking, burnt reverse clutches etc... Get a scanner on it to verify no electrical faults, check the fluid condition and take it to a pro! Not much else he can do in this case I'm afraid.
The no reverse sounds more like he may have stripped the sun shell or a combination of the two .
__________________
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by performabuilt
The no reverse sounds more like he may have stripped the sun shell or a combination of the two .
This car is pretty much babied--Never had any issues at all-slipping etc.
Thanks for the Post Chris!
The sunshell is used in second a reverse but it diferent ways, When the center strips you lose reverse and second, Its and internal part of the trans.
__________________
Originally Posted by Wes Brannon
Where the hell is the tranny dipstick
98 corvette
98 corvette
no dipstick on the c5.
you have to warm the car up to full operating temps.
have it in the air,
there is a drain/fill plug on the drivers side of the trans pan.
once warmed up crack open the drain plug.
if a fluid comes out, your ok.
if nothing comes out time to fill until it does, then install the plug.
been there, done that (about a 1000times...lol < ex c5 owner)
btw. its about 2in from the hot azz exh pipe..be careful...LOL
Trending Topics
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by usd2sing
no dipstick on the c5.
you have to warm the car up to full operating temps.
have it in the air,
there is a drain/fill plug on the drivers side of the trans pan.
once warmed up crack open the drain plug.
if a fluid comes out, your ok.
if nothing comes out time to fill until it does, then install the plug.
been there, done that (about a 1000times...lol < ex c5 owner)
btw. its about 2in from the hot azz exh pipe..be careful...LOL
you have to warm the car up to full operating temps.
have it in the air,
there is a drain/fill plug on the drivers side of the trans pan.
once warmed up crack open the drain plug.
if a fluid comes out, your ok.
if nothing comes out time to fill until it does, then install the plug.
been there, done that (about a 1000times...lol < ex c5 owner)
btw. its about 2in from the hot azz exh pipe..be careful...LOL
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by performabuilt
The sunshell is used in second a reverse but it diferent ways, When the center strips you lose reverse and second, Its and internal part of the trans.
about 1.200.00 to repair--Locally!--What do you think?
FormerVendor
Joined: Oct 2006
Posts: 3,123
Likes: 3
From: D-F/W
$1,200.00 sounds cheap. Especially if it includes the R&R. But, if he is looking for astock rebuild, or gonna get it done from a small one man shop with no overhead... sounds good. Hard to tell.
Does that include a converter replacement or freshen up?
g
Does that include a converter replacement or freshen up?
g
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by Ratchthed
$1,200.00 sounds cheap. Especially if it includes the R&R. But, if he is looking for astock rebuild, or gonna get it done from a small one man shop with no overhead... sounds good. Hard to tell.
Does that include a converter replacement or freshen up?
g
Does that include a converter replacement or freshen up?
g
Small local Transmission shop. Amaco wanted 2k
Thanks
Wes
Good luck hope all goes well for you.
__________________
FormerVendor
Joined: Oct 2006
Posts: 3,123
Likes: 3
From: D-F/W
Originally Posted by Wes Brannon
He's going to be able to use my 3200 converter thats in there now!!
Small local Transmission shop. Amaco wanted 2k
Thanks
Wes
Small local Transmission shop. Amaco wanted 2k
Thanks
Wes
g
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by Ratchthed
Tell you what, pm me me a list of the components they plan to use and I'll try to advise if you would like.
g
g
He didnt say what he was puting in in detail--he did say the "sun shell" would be a "heavy duty" part--so i'm not real sure!
Thanks for the help though, If I find out next week when it goes in I will let you know.
Wes
FormerVendor
Joined: Oct 2006
Posts: 3,123
Likes: 3
From: D-F/W
Sounds like he is using a "Beast" sunshell. Or at least an upgraded part. Good.
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by Ratchthed
Sounds like he is using a "Beast" sunshell. Or at least an upgraded part. Good.
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
Thread Starter
9 Second Club
iTrader: (24)
Joined: Oct 2006
Posts: 2,796
Likes: 1
From: Kennesaw, Georgia
Originally Posted by Ratchthed
Sounds like he is using a "Beast" sunshell. Or at least an upgraded part. Good.
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
I guess my concern is that your friend will be back in the same boat in a relatively short time. $1,200.00 is a bunch of money right? If it were me I would want to do my best to make sure it does not fail in a short period of time by utilizing the latest in upgrades. I would bet your friend is going to lean on it a bit when he gets it back. I know I would! LOL
g
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by HUNTER02SS
Hey gilbert, If you are refering to me,i am going with a 6 speed. I am tired of messing with the automatic stuff for now.i will definatly be all in it though.
Teching In
Joined: Jan 2007
Posts: 24
Likes: 0
Originally Posted by Ratchthed
Bwahhhaaaahahahahaha!!! You guys, I swear!
Alright who's got the friggin Vette with the grenaded tranny already!
This shell game is wearin' me out!
g
Alright who's got the friggin Vette with the grenaded tranny already!
This shell game is wearin' me out!
g
