Torque specs for trans mount please
Thread Starter
Joined: Apr 2007
Posts: 330
Likes: 1
From: Chicago, Illinois (far south)
I saw the 18 for the mount to the trans. The nut on the bottom (mount to crossmember) and the crossmember (to frame) are not listed. They are for the t56 in the link you provided.
I see that they are only giving the spec's for the cross member and the mount nut for the t56. However the mounts and the cross members are basically the same and I think that you will be just fine using those spec's. I will have to look at the service manual when I get to the shop today and verify this for you. Vince
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
if you tighten the bolt past 18 ft/lb torque will that cause a lot of vibration from that area since there is more pressure? when mine was put on it was just tightened really well. we didn't go by torque specs.
4l60e, crossmember, ls1, ls1tech, mount, nut, spec, specification, specifications, specs, torque, tourqe, tranny, trans, transmission
