ls fox motor mounts
#1
ls fox motor mounts
I have a 83 mustang fox body and am looking for motor mounts to bolt into the stock k member is there any available? I building them the best or only way? Is there a write up on how to build motor mounts? ( how to place the motor e.c.)
I have done a search and not found anything if this is already be discussed I apologize in advance.
I have done a search and not found anything if this is already be discussed I apologize in advance.
#2
open your searches. brp hotrods makes drop in motor mounts. but they're expensive. or search "mustang mounts" and you see plenty of easy examples of how to make your own. some 1/4in flat steel, and some 1 1/2in square or round stock. very simple. get the motor back and low as possible and keep it level
#3
LS1Tech Sponsor
iTrader: (5)
Dirty Dingo is working on them. Should be reasonably priced and available soon.
Jon
PSI
Jon
PSI
__________________
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
#4
open your searches. brp hotrods makes drop in motor mounts. but they're expensive. or search "mustang mounts" and you see plenty of easy examples of how to make your own. some 1/4in flat steel, and some 1 1/2in square or round stock. very simple. get the motor back and low as possible and keep it level
#6
Trending Topics
#8
I built my own. Not as nice as brps but I went through every step I could think of to make sure that the engine was centered and checked engine angle for every little thing. It took me a while but it turned out good. I fabricated them for use with the upr 50 k member.