Anyone running manual heater core bypass valve ??
#1
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Jan 2011
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Anyone running manual heater core bypass valve ??
Thinking of doing a manual valve setup on my car. I recently changed my giant foxbody hvac system and installed a small stand alone heater. Now this heater is simple it's either going to run or be totally turned off including the coolant. I was looking into the factory setups (explorer and f body) but they all run off vacuum and I don't need that. Can any of the vacuum setups be manually set? Do they recirculate or just block the heater core ? I was also thinking just get a T fitting and some valves and valve off the heater core when not in use and open the circulation tube. Any help or ideas I'd appreciate.
#2
Teching In
iTrader: (2)
Join Date: Dec 2006
Location: Los Angeles, CA
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Old air products. They make a cable pull bypass valve that works.
http://www.oldairproducts.com/catalo...sort=3a&page=2
http://www.oldairproducts.com/catalo...sort=3a&page=2
#5
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Jan 2011
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Old air products. They make a cable pull bypass valve that works.
http://www.oldairproducts.com/catalo...sort=3a&page=2
http://www.oldairproducts.com/catalo...sort=3a&page=2
Yes exactly what I'm looking for thanks
#6
Thinking of doing a manual valve setup on my car. I recently changed my giant foxbody hvac system and installed a small stand alone heater. Now this heater is simple it's either going to run or be totally turned off including the coolant. I was looking into the factory setups (explorer and f body) but they all run off vacuum and I don't need that. Can any of the vacuum setups be manually set? Do they recirculate or just block the heater core ? I was also thinking just get a T fitting and some valves and valve off the heater core when not in use and open the circulation tube. Any help or ideas I'd appreciate.
Like this u could prob convert to manual
Last edited by jimmyg; 01-06-2016 at 06:51 PM.