LS Ford Focus
#21
My son is about to get his license and I was thinking of getting a focus for him....
HAH. Might was well give him a loaded pistol, bottle of whiskey and bag of oxys, he would live longer with those than if I gave him a car like that.
Insane build
HAH. Might was well give him a loaded pistol, bottle of whiskey and bag of oxys, he would live longer with those than if I gave him a car like that.
Insane build
#22
I had some really good results on the dyno today.
car did really good.
All runs are done in 2nd gear. I think it would make a little more in 3rd gear. but with the current gear it turns over 170 in third. I am swapping a 3.73 in later this week and will put it back on the dyno after that.
best run was 386whp
car did really good.
All runs are done in 2nd gear. I think it would make a little more in 3rd gear. but with the current gear it turns over 170 in third. I am swapping a 3.73 in later this week and will put it back on the dyno after that.
best run was 386whp
#33
Engine looks right at home in there haha. That's going to be a blast to drive.
Panels look great man.
Do you have enough clearance to close the hood?
You're not too far from, just saw you're in Washington.
Panels look great man.
Do you have enough clearance to close the hood?
You're not too far from, just saw you're in Washington.
#38
TECH Fanatic
Join Date: Aug 2009
Location: Coast of San Mateo County Between Pacifica & HMB
Posts: 1,824
Received 229 Likes
on
135 Posts
Wow!
My dd is a 05 ZX3 with 241K miles, replacing the Engine in My C5 with
a custom built engine. What to do with the stock LS1 coming out?
Hmmm....
Great Job OP in for Results.
My dd is a 05 ZX3 with 241K miles, replacing the Engine in My C5 with
a custom built engine. What to do with the stock LS1 coming out?
Hmmm....
Great Job OP in for Results.
#40
Looks exactly like mine which is a Speedmaster. it flows well but the rubber o-rings did not seal well enough for me and I've had hit and miss luck keeping it from leaking. I also had to countersink all the hardware holding the motor on as it's so slimline it wouldn't sit flush too the block. Maybe they've fixed this by now though.