78 Datsun 280z-------------> 5.3 Build
#310
Stock cube LS1 - ~11.4:1 compression
AFR 205's - milled to 62cc
Cometic .040 MLS gaskets
Vengeance Racing VRX4 (228/230 .588/.592 on a 112LSA )
FAST 90 / Nick williams 92
and all the other goodies that go with it
Its the stock welded R200, with Z31T cv axles
Last edited by STEEPSS; 07-13-2012 at 12:35 AM.
#319
Well I have some news. Not sure if its good or bad.
I took apart my cv axles to replace the boots and found this:
Both ends....
This was the passenger side. 275 street tires, on the street.....
This is a custom axle from a z-car vendor. Its 1.3" in diameter, so just a shade bigger than a ford 9" 28 spline.
ALSO, the driver's side axle (stock Z31T) was completely fine. Splines had NO issues on either end......
On the next "unbreakable" solution i guess. It raises some concern as this was ONLY street tires, on the street.
I took apart my cv axles to replace the boots and found this:
Both ends....
This was the passenger side. 275 street tires, on the street.....
This is a custom axle from a z-car vendor. Its 1.3" in diameter, so just a shade bigger than a ford 9" 28 spline.
ALSO, the driver's side axle (stock Z31T) was completely fine. Splines had NO issues on either end......
On the next "unbreakable" solution i guess. It raises some concern as this was ONLY street tires, on the street.