waxenate

iTrader: (5)

I read some information on rewiring might be a bit difficult.....any tips or people that have done it? This is my first swap so I have plenty to learn!

bjamick

iTrader: (31)

Best thing to do is read the huge sticky. Pretty much everything is covered in that one sticky.

Or go to lt1swap.com

mille_3

iTrader: (1)

+1 on Lt1swap. All the info you ever want on truck harnesses.

1A Dan

iTrader: (9)

i used the LT1swap info when i repinned my harness. print everything out, label ever wire, and take your time.

you will need to convert the injector pigtails to ev1 style and you'll need to determine if you want to use the 5-wire truck maf w/ iat built in or the fbody 3 wire setup. I've got a spare set of injector pigtails kicking around i didnt use from my swap if needed

Pocket

iTrader: (22)

Built my own from a truck harness too. Take your time and do your research. Its a very time consuming job so be patient

waxenate

iTrader: (5)

Lots of great advice...thanks. aS FAR AS THE PIGTAILS i ASSUME i CAN USE THE ONES ON THE INJECTORS NOW JUST BE SPLICING? sORRY FOR CAPS....DAMN CAPS LOCK!

waxenate

iTrader: (5)

Ok....tons of info there....My harness is out of an 01 silverado....which area should I be looking at?

Earl Filter

iTrader: (1)

This, for starters:

http://www.lt1swap.com/vortec_truck_pinouts/2001.htm

and scroll down this page:

http://www.lt1swap.com/2000harness.htm

waxenate

iTrader: (5)

thanks earl....with a little time and alot of luck i should be able to figure it out but just in case can i lean on you from time to time? thanks