BBK mustang swap headers FOR SALE
#1
12 Second Club
Thread Starter
iTrader: (5)
Join Date: Feb 2010
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I know its the wrong section, but I figured I'd get more interest here..
I bought some 1 3/4" BBK ceramic coated 351 swap headers last April....
They went in and out of my 96 mustang several times, so they are scratched up quite a bit..
The Bad: drivers side flange warped during welding since its only 1/4" and its started leaking at the gasket on cyl #1 and #7...
You can either cut both flanges off and weld on 3/8 or try and heat it up and straighten it out.
These fit fine on a 96 with stock 4.6 k. I did massage the firewall just a tad.
I don't need these at all. I soon bought a team z k and upgraded to Dynatechs..
They have about 30 mi total
$300 shipped
I bought some 1 3/4" BBK ceramic coated 351 swap headers last April....
They went in and out of my 96 mustang several times, so they are scratched up quite a bit..
The Bad: drivers side flange warped during welding since its only 1/4" and its started leaking at the gasket on cyl #1 and #7...
You can either cut both flanges off and weld on 3/8 or try and heat it up and straighten it out.
These fit fine on a 96 with stock 4.6 k. I did massage the firewall just a tad.
I don't need these at all. I soon bought a team z k and upgraded to Dynatechs..
They have about 30 mi total
$300 shipped
![](http://i140.photobucket.com/albums/r18/eli07mtz/IMAG0002.jpg)
Last edited by Inbred; 04-18-2011 at 07:30 PM. Reason: added pic
Trending Topics
#9
TECH Regular
iTrader: (7)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
It turns out that these won't work in my 95 without significant rework or firewall mods on the drivers side. This is probably because I elected to set my motor back further than the typical AJE setup. They are officially back up for sale, $260 shipped to the lower 48. FYI, the passenger side fit like a glove & both sides dropped in from the top although I had to undo the steering shaft to get the drivers side in.