71 Chevelle+LY6+T56,
05-02-2013, 10:20 PM
#246
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
Yes I bought kit off eBay for $134. It was just a bit short so I cut it up to make it work (just the front section) hopefully an upholstery shop can hook me up with a better solution when I get back from power tour.
05-04-2013, 02:28 AM
#250
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
Factory bracket and factory compressor. I set it up this way when I test fit the engine and Trans. I kept hearing its hard to do or it requires crossmember mods. I found it rather easy to accomplish. Not sure what page it's on but it's all covered on here.
05-16-2013, 06:02 PM
#254
TECH Enthusiast
Thread Starter
iTrader: (4)
Join Date: Dec 2005
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
Thanks wingman, I'm finally ditching the 4.88 gears for 3.73's. should a dream to drive daily now. Ill get some pics with the carpet done and seats in.
On a sad note. I had the lower armrest panels for the rear seat and I guess they got thrown out when my nephew cleaned up some stuff for me. There goes more $ to spend on repop poo parts...
On a sad note. I had the lower armrest panels for the rear seat and I guess they got thrown out when my nephew cleaned up some stuff for me. There goes more $ to spend on repop poo parts...
06-02-2013, 10:31 PM
#259
Launching!
iTrader: (13)
Join Date: Feb 2008
Location: Riverside, Ca
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Can you post more info on how you did the brackets and so on for the gauges. That is what I am working on and would like some pointers or templets if u have any.
