4L60E transmission question
#21
On The Tree
Thread Starter
#23
On The Tree
Thread Starter
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I had the day off so I was running around looking for transmissions & I found a couple of them. One was a 2WD from a Tahoe with a 4.8 & the other was in a 2WD 2002 Tahoe with a 5.3 in it. Will the 5.3 trans work fine with mt 2002 Sierra engine? What about a tranny that came behind a 4.8? Are they the same & will that one work?
#24
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
this post help you deal with all problem of 4L60E Transmission
Symptoms Of The Car When 4l60e Transmission Not Working Properly
read it here
http://www.4l60etransmission.org/category/perfectly/
Symptoms Of The Car When 4l60e Transmission Not Working Properly
read it here
http://www.4l60etransmission.org/category/perfectly/
#25
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
A 4L60e from a 98-02 V8 f-body, 04-06 GTO, 99-07 GM 2WD V8 1500 trucks and SUVs will work. Vans are iffy. You have to make sure it had a 5.3 V8. They used a lot of 5.7 vortec motors in the Vans till the late 2000s.
If you decide you would like a built 4L60e let me know. I'll work up a quote for you.
If you decide you would like a built 4L60e let me know. I'll work up a quote for you.
I have a question. I’m doing a 03 5.3 carb swap. With a 4l60e transmission. What wires can I get rid of from the harness that is going to the 5.3 pcm. I got the motor and trans with a complete harness and pcm but it went into vats mode which is why I’m doing a carb swap
#26
TECH Senior Member
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I have a question. I’m doing a 03 5.3 carb swap. With a 4l60e transmission. What wires can I get rid of from the harness that is going to the 5.3 pcm. I got the motor and trans with a complete harness and pcm but it went into vats mode which is why I’m doing a carb swap
#27
11 Second Club
iTrader: (88)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I have a question. I’m doing a 03 5.3 carb swap. With a 4l60e transmission. What wires can I get rid of from the harness that is going to the 5.3 pcm. I got the motor and trans with a complete harness and pcm but it went into vats mode which is why I’m doing a carb swap