LeanPocket

iTrader: (6)

albeit they are 9000$ ..

87DodgeD150

iTrader: (18)

I'm all for pissing off brand purists and nuthuggers but I may have to pass for $9000 lol

Update: Part of my cooler lines came in. I hate waiting on parts

87DodgeD150

iTrader: (18)

The truck is running pretty good. Did the first oil change and that turned out well.
Putting some miles on the motor. Its crazy to feel how much more powerful this motor is compared to my old dodge motor. We havnt even touched driving tunes or wot at all.
Heres a quick walk around vid. Only one issue thus far. My oil cooler swivel fittings leak oil on the pressure side which is annoying so Ill have to address that soon.
http://vid101.photobucket.com/albums...0907141741.mp4

Mattster

I'm looking into doing this on my 87 W150 truck. Need to steal your engine mounts.

IronBlocked

Badass truck!

87DodgeD150

iTrader: (18)

Thanks man! Progress has been super slow at the moment. Still waiting to have my rear gears reset up. The weather and holidays haven't been helping either.

87DodgeD150

iTrader: (18)

Sit Rep: Its been a while since I posted anything. The truck is running like a raped ape other than an odd random misfire I'm trying to figure out. So far anything under 50mph is just wheel spin when I roll into it. The truck is not insanely quick as some of the other vehicles on here but it's quick enough to be fun. I suspect mid to low 12's if I can get it to hook. Once I get this misfire dealt with it will be finished dyno tuned then off to the track with some drag radials.

87DodgeD150

iTrader: (18)

After a year I finally get the truck to the track. I'm pretty impressed so far.

87DodgeD150

iTrader: (18)

Finally got the truck strapped to the dyno. Made a few improvements. Ditched my original engine mounts for some ls swap weld in poly mounts. Had a bad tps and my fuel filter was going out. Fixed all that and let it have it. I noticed I need to fix some pictures on here since my links somehow got broken so I'll fix that soon. I really like how the cam and tbss intake match pretty well and give me a dang good torque curve. Shift points are now set to 6500. I'm hoping with a taller radial and a few hundred more rpm it will see 11s.

casias

iTrader: (1)

That's some really nice numbers. What was your final specs - compression ratio, engine size, cam etc?

87DodgeD150

iTrader: (18)

Tick Performance SNS Stage 2 cam
TBSS intake. 90mm Tb 100mm ls7 card maf.
370ci
I believe my static comp is 12.2:1 with my tsp stage 2.5 5.3 heads. 28 degrees of timing.

Not sure what my drive train loss with a 70" driveshaft is, drum brakes, and heavy wheels.

racing1g

Thought I would bring this thread back from the dead just to tell you good job on your swap! I have a buddy with an 89 D100 and we are swapping a 525 hp connect and cruise into it. We are currently in the home stretch and finishing up some wiring on it, I was wondering if I could pick your brain on the mating of the LS harness and factory bulkhead harness?