Project "SVT Chevy" now blown!
11-17-2013, 04:00 PM
#107
weather was a lil bit nicer today so decided to drop the diff. wasnt as hard as i thought it was goin to be.
the parts pile:
ever see a tire blow out while just sitting? i was driving on this before i pulled the car apart and it was good when i sat it in the backyard.
the parts pile:
ever see a tire blow out while just sitting? i was driving on this before i pulled the car apart and it was good when i sat it in the backyard.
11-30-2013, 05:35 PM
#112
well fabd up some coil pack relocation brackets. gotta paint them, run the wiring and wrap the plug wires and coils with some summit racing heat tape. yes i know theyre a little close to the headers but i think itll work, if not then ill move them. also got another freebie the other day, buddy gave me a set of sn95 front calipers.
fab'd up a bracket for my pcm to mount under the dash.
went to the junk yard today cause it was 50% off and picked up some GT sway bars and a newer cobra bumper.
the packs arent tightened down in the pics.
cobra bumper i found. then i rough cut it, gotta get my air saw and do the finer cut.
fab'd up a bracket for my pcm to mount under the dash.
went to the junk yard today cause it was 50% off and picked up some GT sway bars and a newer cobra bumper.
the packs arent tightened down in the pics.
cobra bumper i found. then i rough cut it, gotta get my air saw and do the finer cut.
12-07-2013, 05:11 PM
#116
well got a bunch of stuff the other day. pretty much all my fuel stuff, and trans dipstick. waiting for my battery relocation stuff still. was supposed to be here this past week.
anyways weather cleared up enough for me to get some work done.
hooked up my fuel rails and threw the rest of the fuel line to the back of the car (floor is all wet so didnt do anythign else with the fuel). installed my dipstick which needed some grinding to fit, and mounted my passenger side coil packs but i need to do the wiring for them. oh also found out that my boss will let me build my power steering hoses at work so i mocked up some fittings.
oh found out that 2003 3500 silverado 8.1l plug wires were perfect for what i needed. they come out off the spark plug at pretty much a 90 degree angle and are a little longer then f-body and the truck wires.
dont mind the wiring im not done yet.
sorry for the crappy pics my cameras flash decided to stop working.
anyways weather cleared up enough for me to get some work done.
hooked up my fuel rails and threw the rest of the fuel line to the back of the car (floor is all wet so didnt do anythign else with the fuel). installed my dipstick which needed some grinding to fit, and mounted my passenger side coil packs but i need to do the wiring for them. oh also found out that my boss will let me build my power steering hoses at work so i mocked up some fittings.
oh found out that 2003 3500 silverado 8.1l plug wires were perfect for what i needed. they come out off the spark plug at pretty much a 90 degree angle and are a little longer then f-body and the truck wires.
dont mind the wiring im not done yet.
sorry for the crappy pics my cameras flash decided to stop working.
Last edited by Swapper; 12-07-2013 at 05:28 PM.
12-08-2013, 04:24 PM
#117
finished up some more underhood wiring, bolted down the cereal box, supercharger, throttle body elbow, throttle body, and ran fuel line to back of car. still need to drop the tank and install the new pump and vette regulator. still waiting for my battery wiring stuff.
