Throttle cable ? for Mustang guys
03-28-2006, 04:16 AM
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: S.E. Tx
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Throttle cable ? for Mustang guys Ineed to know how long of a throttle cable you used? I am planning on using a LOKAR cable and want try and have it in hand when I start the swap next week!
03-28-2006, 10:16 PM
#5
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: S.E. Tx
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by nuckifuts
from the firewall to the holddown bracket is 27 inches on my car(sleeve length). from the firewall to the actual end where it attaches to the throttle is 33. i hope this helps.
03-29-2006, 06:52 PM
#7
my car was originally a 2.3 Auto so it had a tv lever on the trans which is almost identical to the stock ls1 throttle body lever except it has the ball & socket stud to use with ford linkages.(sorry if this is confusing 
). so i just took off the ls1 lever with a die grinder and welded on the ford part. even the hole in the center matched up with a few hits of the file. another way i was going to do it if i didnt have the lever was to take off the GM style stud and put on one of these [pic below] from here http://www.jegs.com/webapp/wcs/store...0313&langId=-1 is this even remotely clear?
). so i just took off the ls1 lever with a die grinder and welded on the ford part. even the hole in the center matched up with a few hits of the file. another way i was going to do it if i didnt have the lever was to take off the GM style stud and put on one of these [pic below] from here http://www.jegs.com/webapp/wcs/store...0313&langId=-1 is this even remotely clear? 
