third gen swap

Reply Subscribe

Thread Tools

Search this Thread

Dec 14, 2007 | 10:07 PM

slolt1

Thread Starter

TECH Regular

iTrader: (75)

Joined: Dec 2005

Posts: 497

Likes: 0

third gen swap

i am doing the swap and trying to fiqure out where to put the ecm any help will be great

Dec 15, 2007 | 12:43 PM

Spike-Z

Launching!

iTrader: (2)

Joined: Dec 2006

Posts: 247

Likes: 0

From: Beloeil, Quebec, Canada

In the engine compartment if youre using a stock harness, or under the dash if you use an aftermarket supplier. You could always extend the wires of the stock harness to put it where you want. I placed mine under the dash, @ the OEM location.

Dec 16, 2007 | 10:39 AM

a10beav

TECH Apprentice

Joined: May 2006

Posts: 305

Likes: 0

I did the same.

Dec 16, 2007 | 10:49 AM

DiabloFormula

Banned

iTrader: (58)

Joined: Mar 2004

Posts: 756

Likes: 0

From: Leola, PA

Here's what I did.

Attached Thumbnails

Dec 16, 2007 | 11:06 AM

grifter757

TECH Apprentice

iTrader: (11)

Joined: Aug 2006

Posts: 370

Likes: 0

From: Virginia Beach, VA

Mine is the stock location to.

Dec 17, 2007 | 10:25 AM

slolt1

Thread Starter

TECH Regular

iTrader: (75)

Joined: Dec 2005

Posts: 497

Likes: 0

are you able to put it in the stock location runing the air box

Dec 17, 2007 | 03:12 PM

a10beav

TECH Apprentice

Joined: May 2006

Posts: 305

Likes: 0

You mean the heater core? Yea, it'll fit. It's a tighter fit than the stock ECM but it works. You'll just need to create a bracket to hold it in place.

Trending Topics

Never knew about this Trans Am before

9

232
Starting issues

20

638
Epic SRK B/S thread of 2019

12.7k

561.1k
LT1 camero. Fastest stock NA pony car ever?

1.1k

30.4k
Compression check

9

317

Dec 17, 2007 | 09:04 PM

ghettocruiser

TECH Fanatic

iTrader: (17)

Joined: Mar 2006

Posts: 1,746

Likes: 2

From: West Chester, PA

I put mine in the stock location. NO extension of the PCM wires was needed... Only a handful of the wires for the three "C" connectors needed tobe lengthened a bit, but only because I wanted those connectors to sit on the wheel well just like on the 4th gens. I could have gotten away without extending them.

J.