12.9 @ 106.9MPH ALL MOTOR Maxima!
11-08-2010, 04:16 PM
#1
12.9 @ 106.9MPH ALL MOTOR Maxima! My daily driver is moving! 
I was really excited when I got this slip! A lot of hard work has paid off right here.
Ran a couple of other passes, but could not get the car to hook. All passes were around 106-107MPH.
Runs were made at KCIR. Density Altitude: 1712 feet || Relative Density: 95.08 %
http://www.dragtimes.com/da-density-...time=1:54%20PM
Here are the mods:
Fujita intake
3" exhaust back to a single magnaflow muffler (Still running the stock exhaust manifolds and stock cats)
15lb Lawnmower battery (only cost $25 at walmart)
26x11.5-16 ET Streets mounted on FD RX7 wheels (super lightweight)
Lots of weight reduction
Blue tape rear "diffuser". (Blocks off the air gap between the gas tank and the rear bumper cover. Reduced drag a lot. When you see honda civics with holes in the rear bumper, this is pretty much doing the same thing. Diverting the air from getting trapped in the rear bumper. I gained a lot of mph from last time with this being pretty much the only change.)
I didn't use the spare tire skinnies this time, as this track would not allow it.
Really simple setup with very little money invested.
My goal was to hit 12s without headers and a tune. If I can get the car too hook, it should run some 12.7s in the near future.
Here is the good stuff:
Maxima in "race" trim
Me and Harold's(Grey99max) beast! Harold is living proof that this 12 second pass happened.
Here is the motor, nothing special.
Here is proof of the stock manifolds
Here is my amazingly ghetto but functional "diffuser"
Gained ~2mph with just this change.
Here are the slips:
Spun a little bit on the launch. I was super excited when I got my 12.9 slip.
Spun quite a bit on the launch.
Spun a lot on the launch.
Car feels really good. Absolutely lights up the street tires on the street.
Let me know what you guys think!
I was really excited when I got this slip! A lot of hard work has paid off right here.
Ran a couple of other passes, but could not get the car to hook. All passes were around 106-107MPH.
Runs were made at KCIR. Density Altitude: 1712 feet || Relative Density: 95.08 %
http://www.dragtimes.com/da-density-...time=1:54%20PM
Here are the mods:
Fujita intake
3" exhaust back to a single magnaflow muffler (Still running the stock exhaust manifolds and stock cats)
15lb Lawnmower battery (only cost $25 at walmart)
26x11.5-16 ET Streets mounted on FD RX7 wheels (super lightweight)
Lots of weight reduction
Blue tape rear "diffuser". (Blocks off the air gap between the gas tank and the rear bumper cover. Reduced drag a lot. When you see honda civics with holes in the rear bumper, this is pretty much doing the same thing. Diverting the air from getting trapped in the rear bumper. I gained a lot of mph from last time with this being pretty much the only change.)
I didn't use the spare tire skinnies this time, as this track would not allow it.
Really simple setup with very little money invested.
My goal was to hit 12s without headers and a tune. If I can get the car too hook, it should run some 12.7s in the near future.
Here is the good stuff:
Maxima in "race" trim
Me and Harold's(Grey99max) beast! Harold is living proof that this 12 second pass happened.
Here is the motor, nothing special.
Here is proof of the stock manifolds
Here is my amazingly ghetto but functional "diffuser"
Gained ~2mph with just this change.
Here are the slips:
Spun a little bit on the launch. I was super excited when I got my 12.9 slip.
Spun quite a bit on the launch.
Spun a lot on the launch.
Car feels really good. Absolutely lights up the street tires on the street.
Let me know what you guys think!
11-08-2010, 04:49 PM
#2
On The Tree
iTrader: (5)
Join Date: Nov 2010
Location: Tahlequah, OK
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Good run man, thats insane for a stock manifold car. Gives me a whole new perspective on 6th gens lol. I've seen your low 13 second thread on maxima.org and i was amazed by that time even. Good **** krazy4.
Trending Topics
11-09-2010, 02:49 PM
#9
11 Second Club
Join Date: Sep 2007
Location: WALDORF MD
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
thats moving, I had a 04 auto, wish it was a m6. My boy had a bolt on 02 that went 13.2and everyone thought it had alot of work, so people most think you spraying. Congrats
11-09-2010, 03:44 PM
#10
On The Tree
iTrader: (5)
Join Date: Nov 2010
Location: Tahlequah, OK
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Oh no doubt, the 6th gen section is a strange place lol. Makes me really want one now lol. I can only imagine how that car would run with headers and a damn good tune.
