First Time out 1.47,6.69@105 N/A 1/8 mile
10-14-2006, 10:35 AM
#1
Launching!
Thread Starter
iTrader: (5)
Join Date: Feb 2006
Location: Lenoir City, TN
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
First Time out 1.47,6.69@105 N/A 1/8 mile First time out on a three year project.Just worked on suspension and tire pressures.Left off trans brake @ 4200,front end was about waste high.Have alot more tuning to do with carb,and need to get anti-roll bar before the nitrous goes on. Just thought I'd share, I'm happy with the results so far.Will try to get some pics next weekend, was to hectic this weekend.6.69@105mph,1.47 60ft.Here are a couple of pics of the car completed.
Last edited by Hot Copper Z; 10-23-2006 at 06:03 PM.
10-22-2006, 09:39 AM
#6
Launching!
Thread Starter
iTrader: (5)
Join Date: Feb 2006
Location: Lenoir City, TN
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys,took it to a car show/race yesterday,got runner up in the car show, got beat by a beautiful 66 chevelle show car,so I don't feel too bad.They should have let us race for first place.ha ha.Then clicked off a 6.64@105.2,1.45 60ft.Spray coming soon!
Trending Topics
That is a badass color !!
11-24-2006, 11:40 PM
#10
Launching!
Thread Starter
iTrader: (5)
Join Date: Feb 2006
Location: Lenoir City, TN
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
New pics If I get my anti-roll bar from BMR,and my driveshaft from Denny's I,ll have some new pics from the upcoming weekend.Hope to have the nx wired up by then
11-25-2006, 02:40 PM
#11
9 Second Club
Join Date: Dec 2003
Posts: 170
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Hot Copper Z
If I get my anti-roll bar from BMR,and my driveshaft from Denny's I,ll have some new pics from the upcoming weekend.Hope to have the nx wired up by then
Nice...I have the same setup. Hell my car is red too! I thought you stole it!
I have gone as fast 5.36 in the 1/8 on the spray so good luck. My conversion factor for 1/8 to quarter that I have found the most accurate is 1.5625 for ET. Good luck!
