00blacka4

iTrader: (7)

needing pics...have a ten bolt with MWC torque arm and Anti-roll bar and am having problems with my anti-roll bar hitting the housing and not going to the stock mounting location...maybe i just need to pop those little things off from the factory and center it i dont know help me out....also MWC torque arm is suposed to go with adjuster towards the ground correct? this just doesent seem right to me because that would make the curve of the torque arm towards the top of the car and the straight piece on bottom ? .....PICS NEEDED

Zmg00camaross

iTrader: (11)

Pretty sure the curve goes up.

358chevycamaro

iTrader: (10)

I would be calling their tech line in the morning to find out exactly how it was all built to be installed and work properly myself.

silverz28camaro

iTrader: (20)

You coulda got the edelbrock t-arm, direct fit with a TRZ anti roll kit.

Zmg00camaross

iTrader: (11)

How heavy is that trz bar?

silverz28camaro

iTrader: (20)

It was all chromemoly, they advertised it as 10 lbs lighter, but I think it was only 3lbs lighter if that....but the main advantage is that it works well..helps the car handle alot better without a front sway bar.

And it allows alot of room for bigger exhaust.

00blacka4

iTrader: (7)

what about the anti-roll bar...need pics of that it hits my housing unless im doing something wrong ?? and it doesent sit in the stock mounting locators on the housing from the factory

5.3LJimmy

iTrader: (10)

It sounds to me like you are putting both the torque arm and sway bar on upside down. Try flipping the car over and reinstalling.

00blacka4

iTrader: (7)

THANKS ! i just flipped the car over and it went right on !! hahaha....no acctually i think im going to have to build a 1/4 inch spacer to run between the anti-roll bar and stock mounts and that should clearance my housing...

Magnet

iTrader: (36)

Gettin suspended I see...