what is your 2 step wired too?
what is your 2 step wired too? I'm about to get my mallory 685 that has a built in 2 step and was courious to see what you guys are using to send 12v to activate the 2 step. I was think about wiring up a relay and using one of the horn buttons
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
i tried to wire my 2 step up to the safety switch but both wires would trigger the 2 step ground so ultimately switch doesnt matter if its open or closed... any suggestions other then just wiring up the neutral safety and using that switch just as a stand alone for the 2 step. car is a a4 wire harness as well so the wires going to the safety switch on the clutch are coming from the a4 harness in the console...
well i took apart a anticipation switch i had kickin around and modified it to work with the 2 step... all it took was a solering iron to melt the plastic and change the enagement point. problem was the switch was open when the pedal was push in and closed when pedal released... obviously backwards for the 2 step unless you rigged up a replay. so i took my soldering iron and melted the plastic on the slider and relocated that plastic so the switch now closes when the pedal is pushed in! hahaha took only 1 min and works flawlessly.
10 Second Club
Joined: Aug 2010
Posts: 4,465
Likes: 192
From: Harford Co. Maryland
If wired to the brake switch, won't it come on everytime brakes are applied and over the rpm limit it's set at ?
Just asking since I was looking at this also and thought it wouldn't work.
Just asking since I was looking at this also and thought it wouldn't work.
