Wolfe Adjustable Rear Spring Perches, Who's Running Them?
#21
TECH Fanatic
iTrader: (24)
bfh to the area around the TQ arm, I am running Moser NON fabbed housing and Burkhart TQ arm. its a tight fit, but it nothing is hitting.
IDK if most of my pics I had in my build thread where with the 8" springs or not, I used to run 10" springs but never could get the car to sit low enough, but the 8" springs did just what I wanted with the car.
IDK if most of my pics I had in my build thread where with the 8" springs or not, I used to run 10" springs but never could get the car to sit low enough, but the 8" springs did just what I wanted with the car.
#23
TECH Fanatic
iTrader: (9)
Join Date: May 2005
Location: Longview, TX
Posts: 1,085
Likes: 0
Received 0 Likes
on
0 Posts
My floor took a lot of work to get it to sit that low, and I ran the stock fuel tank for a long time but I'm finally removing it because the rear end has almost rubbed a hole through it.
#24
Ultimately I'd like to get the car to tuck more than where it's at in the pics below. Just need to find out what all is hitting and find a way to make clearance.
So far I have enough room/clearance to get the tires up into the wheelwell but I think the axle tube is hitting the 4" exhaust over the axle.
So far I have enough room/clearance to get the tires up into the wheelwell but I think the axle tube is hitting the 4" exhaust over the axle.